Daystar Reflector - Air Coolable

DAUN
$119.95

The Daystar has evolved from our high performance GLX commercial greenhouse reflector. The greenhouse challenge is to offer not only the most uniform lighting pattern for crops, but also the most efficient lighting systems possible so that the crop can get to market at the lowest possible production cost. There is no room for poor performance anywhere. The Daystar uses the highest purity and efficiency European aluminum and was designed by the finest reflector engineers in the country. Its combination of uniformity and efficiency is unsurpassed in our industry. We urge you to compare the Daystar against other reflectors on the market and find out why our design is the leading choice for 1000W sodiums and halides in both the competitive commercial greenhouse market and in the demanding eyes of your customers.

  • Super efficient with both 1000W sodium and halide
  • Built-in cord set
  • Integrated hangers
  • Low profile design for lower clearance areas
  • Patented cool running double wall design
  • Compact and lightweight; easy to hang
  • Designed exclusively for Hydrofarm by America's foremost lighting design engineers
  • World's finest European reflective specular aluminum: 99.85% pure with 95% reflectivity
  • Instructions and lighting recommendations included
  • CSA certified

Reflector size: 7 3/8"H x 12 1/2"W x 18 1/2"L
Accepts: Sodium 250W, 400W, 430W, 600W, 750W, 1000W - Halide 250W, 400W, 600W, 1000W

9.6 lbs.
22.0L x 16.0W x 11.0H
Horizontal

My lamp, ballast and reflector combination is not working. How can I fix this?

For traditional mogul type lamp systems: The problem might be a bad connection in the mogul socket. Make sure to disconnect the unit from the power supply, and then look inside the mogul socket for a metal tab. Pry this tab upwards a little bit to make better contact with the bulb base. For double-ended type lamp systems: Improper seating/installation of the DE lamp is by far the most common reason for malfunctions with DE systems. Disconnect the lamp cord from the ballast and unplug the ballast's power cord from the power source, then check whether the lamp is properly seated in the lamp holders. Turn your reflector upside down so that the lamp and lamp holders are facing upward. Try sliding the lamp holders to their open position (outward), repositioning the lamp and the lamp's wire ends/leads, and then re-securing the lamp by sliding the lamp holders closed again (inward, toward the lamp). The lamp's wire leads must be fully seated in their slots before sliding the socket ends closed. If uncertain about how the lamp holders work, please refer to the photos provided in the instructions (available under the Product Info tab). Wear gloves when handling the lamp to prevent fingerprints/skin oils from being left on it. If the lamp needs cleaning, use a soft dry cotton cloth to wipe off fingerprints or oils.