Daystar 6" Air Cooled Reflector

DA6AC
$159.95

The Daystar AC is the answer for those wanting high performance coupled with maximum air cooling potential. Utilizing the same patented double wall design and reflective material as our flagship Daystar unit, the Daystar AC adds two 6" integrated flanges for cooling air flow from an optional fan. The 6" diameter encompasses most of the tunnel-like interior ensuring more complete air flow than common air cooled units. This combination allows for closer plant placement plus better growth and improved ability to control growing area temperatures.

  • Same incredible light delivery as the Daystar
  • Plus 6" flanges for straight through fan-powered supercooling capability
  • Built in socket and 15' lamp cord for quicker, easier installation; no extra cord set required
  • Excellent in hotter growing areas
  • Cooling allows closer-to-plant positioning for best results
  • Enclosed wire channel protects wiring
  • Improved fully sealed tempered glass lens included, along with hangers and lighting recommendations

Reflector Size: 7.3"H x 12.5"W x 22.5"L
Accepts: Sodium 250, 400, 430, 600, 750, 1000 - Halide 250, 400, 600, 1000

 

15.1 lbs.
24.8L x 15.2W x 11.6H
Mogul (E39)
Horizontal

Hydrofarm: Daystar Air Cooled Reflector - Out of the Box

My lamp, ballast and reflector combination is not working. How can I fix this?

For traditional mogul type lamp systems: The problem might be a bad connection in the mogul socket. Make sure to disconnect the unit from the power supply, and then look inside the mogul socket for a metal tab. Pry this tab upwards a little bit to make better contact with the bulb base. For double-ended type lamp systems: Improper seating/installation of the DE lamp is by far the most common reason for malfunctions with DE systems. Disconnect the lamp cord from the ballast and unplug the ballast's power cord from the power source, then check whether the lamp is properly seated in the lamp holders. Turn your reflector upside down so that the lamp and lamp holders are facing upward. Try sliding the lamp holders to their open position (outward), repositioning the lamp and the lamp's wire ends/leads, and then re-securing the lamp by sliding the lamp holders closed again (inward, toward the lamp). The lamp's wire leads must be fully seated in their slots before sliding the socket ends closed. If uncertain about how the lamp holders work, please refer to the photos provided in the instructions (available under the Product Info tab). Wear gloves when handling the lamp to prevent fingerprints/skin oils from being left on it. If the lamp needs cleaning, use a soft dry cotton cloth to wipe off fingerprints or oils.